16-axis motion control card / RTEX BUS / servo / for welding machines

1)RTEX BUS motion control card for welding machine
2)Supports any parameter of axis servo
3)independent control
4)ISO2008,CE

Description:
16 axes RTEX motion control card, applies standard Ethernet 100BASE and supports 100Mbit of bandwidth, which makes this card supporting high-speed throughput of data transmission. Its hardwarenetwork protocol function makes it can communicate in real time, and its modular design makes its solution much easier.

Function:
Base on RTEX BUS, 16 axes;
Random 2-6 axes linear interpolation;
Supports the parameter’s reading and inputting of any axis of servo;
Supports the alarm’s reading and clear of any axis of servo;
Supports position, speed and torque control modes, supports hybrid control mode;
Linear acceleration/deceleration;
Read logic position, real position, driving speed and other parameters in real time during motion;
Supports full-closed loop control mode; (it needs to match with Panasonic A5N series of servo)
16 axes can run or stop simultaneously, its hardware has emergency stop function;
16 axes servo, step and I/O control, each axis can control independently;
Indicator prompt function;
Bus module and running module are highly integrated; customers can call motion control AP to realize the control though the customers have no knowledge of hardware.

parameter:
Items
Description
Connection mode: Loop
Physical layer: 100BASE-TX (IEEE 802.3)
Transmission rate: 100 [Mbps]
Nodes: Max 32
Communication cycle: 0.5ms

Communication cable:
5e Shielding twisted pair cable should be 5e or above 5e under standard TIA/EIA-568

Length of the cable:
Max length within nodes:100[m]( for reference)
Max length:200[m]( for reference)