orbital brazing torch

The orbital weld heads HX for compact cooling systems are setting new standards!
"HX" stands for "heat exchanger" and for the welding of pre-mounted elbows in tight pipe bundles of heat exchangers into a pipe coil. There is no other solution as effective as this one in the world!

Due to their compact size, all fully closed or open orbital weld heads commonly available on the market are not suitable for being positioned between the individual pipes of finned heat exchangers.

The HX series scores points in the areas of economy and efficiency when compared to conventional weld heads: The pipe ends of a heat exchanger can be fully fitted with elbows before joining and then welded in any order. For conventional orbital weld heads, the principle of fit elbow, weld, fit elbow, weld etc. applies, always starting from the center of the pipe sheet and working outward. If quality testing reveals a faulty weld later on, all elbows must be disconnected and new ones must be welded on in the worst case scenario (fault in the middle of the bundle) due to the accessibility factor. With the HX head, only the affected elbow would have to be replaced. This design-based advantage also makes the Orbitalum system the ideal tool for unbeatably cost-effective repairs.

Pneumatic clamping system for easy mounting on the pipe elbow
Highly durable thanks to liquid-cooled earth plate and rotor housing
Horizontal, vertical and tilted welding positions are possible
Very robust and ergonomic design
Fast and easy mounting at the tube