Moisture analyzers, moisture meters

The moisture meter will measure wood pieces from 8 to 28% to find the total amount of moisture in a space. It three lights and a carrying case.

Moisture Tester MT-CA: Moisture testing "advanced" by means of the drying oven method What does it measure? The MT-CA provides an individual and serial determination of the water and solvent content of different kinds of sample material, ...

The LMA200 humidity meter is designed to analyze moisture in both liquid and pasty samples with moisture content ranging approximately 8% to 100%. The unit utilizes microwave drying, producing results up to 300 times faster than a drying ...

The family of AA dampness meter is intended for dampness investigation in everyday schedule laboratory uses in research and development in addition to process and quality control. Sartorius presents an extensive variety of dampness meters, ...

The Moisture meter MA family is used for moisture analysis in daily routine laboratory applications in research and development as well as quality and process control. Sartorius offers a broad range of moisture meters, from the user friendly ...

The MS-70, MX-50, MF-50 and the ML-50 are moisture analyzers that utilize the heating and drying method, which compares the weight of a sample before and after heating and drying. Compared with Karl Fischer analyzers, the MS/MX/MF/ML ...

The KF Gas Analyzer is widely recognized worldwide because its system is controlled with tiamo™ and is comprised of one operating unit (TFT monitor) and an analysis module. Because of this system, it is possible to perform all analysis ...

The Testo 606-1 is a device suitable for measuring material dampness. The reading is displayed in terms of weight percentages with the use of stored material characteristic curves for wood materials such as beech, spruce, larch, oak, ...

The Testo 616 is a measuring instrument that allows easier access and observations to measurements of drying floors, walls, and other surfaces. It allows the most suitable time and place for measuring destructions that are essential to ...

The new FLIR MR77 is a rugged, feature-packed moisture meter incorporating a pinless sensor and a wired pin probe to capture moisture readings up to 0.75 below the surface of various wood types and building materials. The unit also incorporates ...

he FLIR MR160 is the only moisture meter with the power to show you where to measure the problem. Featuring Infrared Guided Measurement (IGM) technology powered by a FLIR Lepton® thermal imaging sensor, MR160 helps you quickly see temperature ...

The Elcometer 7000 range offers accurate and easy to use moisture measurement. Available with pin probes or non-invasive for non-destructive testing, the gauges give average moisture content by comparing the change in impedance between ...

The natural feel of the Elcometer 7400 moisture meter makes it easy to use, allowing the pins on the end of the instrument to be pressed into the material to be measured. The thin pins allow easy measurement of the moisture content ...

The Elcometer 7410 Concrete Moisture Meter is an accurate and easy to use non-invasive instrument for non-destructive measurement of moisture content of concrete. The electrodes transmit parallel low frequency signals, calibrated to ...

InfraLab At-Line Tobacco Analyzers have established themselves worldwide as a viable and cost-effective alternative to the traditional gravimetric and CFA (continuous flow analysis) methods for the measurement of: Moisture ...